2nd Quality Carbon Fiber/Bronze ZYLON HM 2x2 Twill 3k 50 5.5oz Remnant 11.5yd

2nd Quality Carbon Fiber/Bronze ZYLON HM 2x2 Twill 3k 50 5.5oz Remnant 11.5yd. Carbon Fiber/Bronze Zylon High Modulus Fabric/Cloth 50 3k 5.5oz 2x2 Twill.

The material is a hybrid of carbon fiber and Zylon. This fabric has a width of 50, tow size of 3k and is woven in a 2x2 twill weave. This is the most widely used pattern in the automotive industry.

This material was woven by reputable weavers across the US, and their long lasting presence in the composite industry will ensure you receive a quality material. Zylon is stronger than carbon fiber when measuring on the basis of a strength to weight ratio. This is an absolutely beautiful fabric and the pictures do not do any justice. To harden the raw fabric into a usable form, you will need the appropriate resin or epoxy for your project. For the colored materials, we suggest one of our resins which cure clear.

Second Quality Fabric Remnant Rolls are short rolls of fabric, which have a defect in the woven fabric in them. These remnant rolls are cut out of the standard fabrics we sell, but from sections of the rolls that have some defects in them. These defects make them not good to use if you want to make cosmetic parts, which have perfect woven fabric in them, but can be used as the inner layers of your parts, or if you are making small parts and can cut around the defects. All remnant rolls are rounded DOWN to the nearest ½ yard.

So a remnant listed as 0.5 yards may actually be between 18" and 35" in length and a remnant listed at 2.0 yards may actually be between 72" and 89" in length. 5.5oz / 186.48gsm. 0.009 / 0.23mm. 4.5opsy / 151.22gsm. The resin consumption provided is for the approximate amount of resin by weight, contained in the final part after processing by vacuum infusion.

This does not account for the resin used in the flow lines and consumables such as flow media or breather cloth. Wet-layup by hand will also have a higher resin consumption in the final part and is dependent upon users techniques.

Vacuum bagging a wet layup will improve the resin content. Too much resin will cause a weaker part, NOT stronger. Average rule of thumb is around 45% (+/- a couple percent). To calculate actual resin % in your part a burn test is used.

For example you have a part weighing 100 grams, you would burn off the resin which would leave the fiber behind. You should have 55 grams of fiber left when your process is working correctly. However you will have waste no matter what method is used. This item is in the category "Business & Industrial\Other Business & Industrial". The seller is "elitemotoring" and is located in this country: US.

This item can be shipped to United States.

MPN: F-392-2Q=REM-11.5yd
Brand: Composite Envisions