Carbon Fiber Twill

Carbon Fiber Made with Kevlar Blue Part Wrapping Kit 2x2 Twill-Large Kit


Carbon Fiber Made with Kevlar Blue Part Wrapping Kit 2x2 Twill-Large Kit

Carbon Fiber Made with Kevlar Blue Part Wrapping Kit 2x2 Twill-Large Kit    Carbon Fiber Made with Kevlar Blue Part Wrapping Kit 2x2 Twill-Large Kit

Carbon Fiber/Blue Kevlar Part Wrapping Kit w Clear Epoxy 2x2 Twill - Large Kit. Selecting materials for wrapping/covering existing parts in carbon fiber just got easier with our pre-made kits. These kits include all of the materials you need to cover your parts in carbon fiber to give them that desired look.

You can also use these kits to produce parts entirely from carbon fiber as well. You will receive the following materials with the kit.

We have 3 different kit sizes that will fit your needs. This kit contains the sizes and quantities highlighted in yellow below. Carbon Fiber/Blue Kevlar Fabric - 3k 5.5oz 2x2 Twill Weave 50. 2:1 Thin Epoxy Resin with Hardener. 48oz Kit (1 Qt epoxy with 16oz hardener). 96oz Kit (1/2 Gal epoxy with 1 Qt hardener). 144oz (3 Qt epoxy with 1.5 Qt hardener).

Epoxy Mixing Tub with Measurements. If you run out of a certain material we can sell any single item by itself.

This resin uses a 2:1 hardener. Mixing 2 parts epoxy to 1 part hardener will give you the appropriate final mixture. The 2:1 hardener has a pot life of 35-40 minutes at 80° F, set time of 5-6 hours and a drying time of 24-48 hours.

This is considered to be a slow hardener, Our 3:1 and 4:1 hardener epoxies will cure much faster. However this 2:1 hardener will provide you with the maximum working time possible and should not be used in temps under 70° F unless a very long curing time is needed. Slow hardener should be used at temperatures above 80° F for optimal overnight curing. Mixing this product below 75°F will increase the potential for under-mixed epoxy which will create wet or sticky areas on your surface. Cold temperatures will also trap more very tiny air bubbles during the mixing which cannot always be removed with the torch/heat gun.

In addition applying the mixed epoxy in temps below 70 degrees F will drastically extend cure times. To warm the epoxy quickly we recommend using either a heat lamp, an electric heater or placing the closed bottles of epoxy in a tub of warm water for 30 minutes.

Getting the epoxy too hot will result in a faster reaction time, so pay careful attention to what you're doing. The item "Carbon Fiber Made with Kevlar Blue Part Wrapping Kit 2x2 Twill-Large Kit" is in sale since Wednesday, April 22, 2015. This item is in the category "Business & Industrial\Other Business & Industrial". The seller is "elitemotoring" and is located in Wausau, Wisconsin. This item can be shipped to United States.

  1. Brand: Composite Envisions
  2. MPN: 724-Large

Carbon Fiber Made with Kevlar Blue Part Wrapping Kit 2x2 Twill-Large Kit    Carbon Fiber Made with Kevlar Blue Part Wrapping Kit 2x2 Twill-Large Kit